Setup Cloudflare for Teams (Zero Trust) WireGuard Config with Pfsense – IPv6 and v4 with full speed

Set CloudFlare Gateway – Interface tab

Once you connected the cloudflare in Wireguard, PFSense created a new tunnel in the interface tab. 

Click on the interface you created.

1. enable interface
2. set IPv4 and IPv6 as static
3. MTU 1280 (this is very important)
4. set static IPv4 and IPv6
5. add gateway for both IPv4 and IPv6
6. Click save

See the screenshoots and you can use same IPs as mine 🙂 – or you can use from the configuration info you fetched from the virtual device.